UMA1213 IR Supplement Rev 1.
Using the UHBX-8X to send an IR command learned from the HR-4P
What you will need to learn an IR command:
HR-4P Programmable RS-232, IR, and I/O Controller
CIR-DET-D2 IR Receiver Cable (Demodulated Type 2)
Step 1: Learning your IR timing using the HR-4P
• First, we learn an IR code from the remote control using the HR-4P GUI and store it into the unit at
any location using the button.
In our example we are going to learn the code for the Power button on the remote.
• Next, click the Download button to recall that learned IR code from the HR-4P unit back into the HR-4P
GUI using the button
• When the download is done, click the Show Config button to display IR code in HEX.
• Then, select the HEX bytes for the Power button and copy them to your clipboard for sending them after
the IS9<cr> command of the UHBX-8X. These hex bytes should be followed by 0x17 and 0x0D to
indicate the end of hex string.
Comments to this Manuals