Hall-research VSA-32 User Manual

© Copyright 2009. Hall Research, Inc. All rights reserved.1163 Warner Ave Tustin, CA 92780, Ph: (714)641-6607, Fax -714-641-6698 Model VSA-32

Model VSA-32 8 Notes on Audio Output The receiver has an “Audio Amplifier” switch with “Normal” and “Boost” settings. For a smaller rooms use the “N

A / V Switch-Cat TM 9 5.0 Windows™ Projector Configuration Software Included in the VSA-32 package is a CD with the application that you need to use

Model VSA-32 10 . Creating the Serial Strings The serial string to the projector can be comprised of ASCII characters, hexadecimal bytes, relay co

A / V Switch-Cat TM 11 3. Source = Aux On / Aux Off These commands are issued when the Aux button is pushed. When the Aux On command is sent, the A

Model VSA-32 12 . Entering hexadecimal bytes into the serial strings Enter Hexadecimal bytes by typing the hexadecimal byte into the box above the

A / V Switch-Cat TM 13 . Selecting the Baud Rate and Parity Select the Baud Rate from the drop down menu that the VSA-32 needs to use to communica

Model VSA-32 14 . Putting the VSA-32 into Operation • After you have successfully uploaded a configuration to the VSA-32 User Interface, disconne

A / V Switch-Cat TM 15 . Resetting the VSA-32 If for any reason you need to reset the VSA-32, press and release source buttons 1 and 3 simultaneou

Model VSA-32 16 7.0 Specifications Resolutions PC resolutions up to 1920x1440 @ 60 Hz & HDTV to 1080p, NTSC, PAL, or SECAM S-Video and CV Vide

Products Designed and Made in the USA

1 A / V Switch-Cat TM Trademarks Used In this Manual Hall Research, HR and are trademarks of Hall Research, Inc. Any other trademarks mentioned a

Model VSA-32 2 Table of Contents 1.0 General...

A / V Switch-Cat TM 3 1.0 General Thank you for purchasing Hall Research’s VSA-32 A/V switching control system. The package is comprised of a 3 inp

Model VSA-32 4 2.0 Features 9 User interface control panel available as 2-gang wallplate or desktop standalone keypad 9 Wall plates available in b

A / V Switch-Cat TM 5 3.0 Installation In a typical installation, the User interface unit is located on a wall or panel and is wired to the connecto

Model VSA-32 6 Please note that most projectors use a unique and non-standard Serial input connector, therefore you need to build your cable acco

A / V Switch-Cat TM 7 Note on CV and S-Video Inputs Do not connect the Composite Video and S-Video inputs simultaneously. Doing so will produce a po