4 x 4 VGA Matrix Switch With Serial Keypad Model VSM-404 User’s Manual Hall Research Technologies, Inc. Order toll-fre
Model VSM-404 8 3.6.1 How to Activate Scan Mode There are 2 types of scan modes: individual scan and all scan. Both scan modes will adhere to the sc
9 4x4 Video Matrix Switch 3.6.2 How to Exit Scan Mode To exit the scan mode hit the Esc key on the keypad and this will cancel all scanning whether
Model VSM-404 10 3.7 Control from Serial Devices (RS-232 Command Protocol) To control the Video Matrix Switch through an attached PC or other serial
11 4x4 Video Matrix Switch 3.7.1 Status and Special Commands There is a special set of codes that can be sent by (or through) the serial device tha
Model VSM-404 12 4. Troubleshooting Make sure that all your connections are solid, and check the state of the LED’s on the front of the unit. Do no
© Copyright 2007. Hall Research Technologies, Inc.. All rights reserved.1163 Warner Ave Tustin, CA 92780, Ph: (714)641-6607 , Fax -6698
1 4x4 Video Matrix Switch Trademarks Used In this Manual Hall Research and (logo) are trademarks of Hall Research Technologies, Inc. Any other tra
Model VSM-404 2 Contents 1. Introduction ... 3 2. Installation a
3 4x4 Video Matrix Switch 1. Introduction The Model VSM-404 is a 4 in x 4 out video switch matrix that provides four independent outputs each capab
Model VSM-404 4 2. Installation and Configuration To set up your VSM-404 Video Matrix Switch system, take these steps: 1. Making sure that the Swit
5 4x4 Video Matrix Switch 2. The Switch’s output ports are the bottom row HD15 female connectors on the rear panel. If all of your output devices a
Model VSM-404 6 3. Operation 3.1 The Switch’s LEDs The LEDs on the 4 x 4 Video Matrix Switch’s front panel indicate which of the Switch’s outputs a
7 4x4 Video Matrix Switch 3.3 Keypad Shortcut After switching to a channel using the [output].[input][enter] format, you can then switch the input o
Comments to this Manuals