Hall-research IRCNT-16 User Manual download pdf

User’s Manual

UMA1207 Rev n/c

IRCNT-16

16 Port IR Router

1.0 Introduction

The Hall Research model IRCNT-16 is used to direct incoming IR signals to

specific components selected by the user. This prevents unintentionally

controlling components that respond to same IR code. Using the IRCNT-16 the

user can direct the IR signal to any one or combination of outputs.

2.0 Features

 Front panel IR sensor

 Pass-through IR supports carrier

frequencies from 30kHz to 50kHz

 IR routes only to selected outputs

 Internal Power supply using

standard IEC connector.

 Rack mountable with included

hardware – only 1RU.

3.0 Installation

The IRCNT-16 requires 5v compatible IR emitters with standard 3.5mm stereo

or mono plug (such as model CIR-EMT2 sold separately).

Tip = Anode (+) Ring or Sleeve = Cathode (-)

Extension cables may be used to increase the range of the IR emitter. Maximum

length is dependent on the gauge of the wire used. Typical performance:

1,000 feet using 20 AWG or thicker 400 feet @ 24 AWG

When you have several identical components near each other and want to

control selected ones, you have to make sure the emittel IR light signal does

not affect the other components. This can be achieved using a blocking cover

such as Hall Research model CIR-EMT2-CVR

1 2

User’s Manual UMA1207 Rev n/c IRCNT-16 16 Port IR Router 1.0 Introduction The Hall Research model IRCNT-16 is used to direct incoming IR signals

Model IRCNT-16 Users Manual CUSTOMER SUPPORT INFORMATION Order toll-free in the U.S. 800-959-6439 FREE technical support, Call 714-641-6607 or fax 7

No comments

Hall-research IRCNT-16 User Manual